RED PRIMULA User's Guide download pdf (Page 63)

13-MAINTENANCE AND CLEANING

Only a proper maintainance and cleaning of the product can assure you the correct functionality and a safe use of your stove.

ATTENTION!

All the cleaning operations of all parts must be performed with the product completely cold and the plug

disconnected.

Disconnect the product from the 230V power supply before performing any maintenance operation.

The product requires little maintenance if used with certied high quality pellets.

DAILY OR WEEKLY CLEANING PERFORMED BY THE USER

Brazier cleaning

Before ignition, always clean the “T” brazier and remove any ash or incrustation from it that might obstruct the air ow holes, paying

attention to hot ash. In the case of ignition failure, or if fuel in the tank runs out, unburned pellets may accumulate in the brazier. Always

empty the residue in the brazier before each start-up. Only if ash is completely cold may a vacuum cleaner be used to remove it. In this

case, use a suitable vacuum cleaner to remove small sized particles.

REMEMBER THAT ONLY A CORRECTLY POSITIONED AND CLEAN BRAZIER CAN GUARANTEE THE IGNITION AND OPTIMAL

OPERATION OF YOUR PELLET PRODUCT. IN CASE OF FAILED IGNITION AND AFTER ANY OTHER LOCK STATE OF THE

PRODUCT, IT IS ESSENTIAL TO EMPTY THE BRAZIER BEFORE PROCEEDING TO RESTART.

For the brazier to be cleaned properly, remove it from its housing completely and thoroughly clean all the holes and the grate on the

bottom. If good quality pellets are used, you will normally only need to use a brush to restore the optimal operating conditions of the

component.

Ash tray cleaning

Remove and empty the “U” ash tray. Wipe away any residual ash before reinserting the tray. Your experience and the quality of the pellets

will determine the ash tray cleaning frequency. However, it is recommended not to exceed 2 or 3 days.

CLEANING THE GLASS

It is recommended to clean the ceramic glass with a dry brush, or if it is very dirty, spray a little specic detergent and clean with a cloth.

ATTENTION!

Do not use abrasive products and do not spray the glass spray cleaner on the painted parts or the door gaskets

(ceramic bre cord).

EXAMPLE OF A CLEAN BRAZIER

EXAMPLE OF A DIRTY BRAZIER

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 75 76

No comments

RED PRIMULA User's Guide Page 63